Few businesses can shut for a week, so any time on site for aluminium shopfronts in Angus and Dundee is planned around the hours you trade. Closed-day or out-of-hours installation can be arranged.
Finishes behave differently at full size. Any sample we show you for aluminium shopfronts is better judged at the premises in daylight, since a colour that looks quiet on a desk can read much louder across a whole elevation.

How should you approach aluminium shopfronts in Angus and Dundee?
Large panes set the logistics for any aluminium front in Angus and Dundee. We look at where a glass vehicle can stop, how far the panes must be carried and whether a lifting aid will fit, because a 3m sheet that can't reach the opening on the day is a wasted trip.
Across Angus and Dundee, the same aluminium section can look sharp or wrong depending on what stands around it. We choose colour on site against the real brick, stone or render at your address, because a RAL chip under office lights tells you very little.
What consents apply to aluminium shopfronts in Angus and Dundee?
Section 26 of the Town and Country Planning (Scotland) Act 1997 sets the test: work that doesn't materially affect the external appearance isn't development. For aluminium shopfronts at premises in the Angus and Dundee area, anything that does needs planning permission, and a true like-for-like replacement usually doesn't. The council confirms how that applies to each site.
How much do aluminium shopfronts cost in Angus and Dundee?
We would budget £2,495 to £11,995 plus VAT for a typical 3 to 7 m frontage. Scope sets most of the figure, so a clear brief at the start does more for the budget than any later change of detail.
| Area | Angus and Dundee |
|---|---|
| Nation | Scotland |
| Towns covered | 5 |
| Main town | Dundee |
| Planning regime | Scotland: 1997 Planning Act and the 1984 Advertisement Regulations |
| Building approval | Building warrant (Technical Handbook) |
| Survey | Free for new work, from our Great Barr base |
Questions about aluminium shopfronts in Angus and Dundee
Can you work with our shopfitter in Angus and Dundee?
Yes. We can supply the front as one package within a wider fit-out, working to the shopfitter's programme and agreeing the floor, ceiling and signage interfaces on the drawings.
How long would an aluminium shopfront take in Angus and Dundee?
Typically 2 to 4 weeks to fabricate once drawings are signed off, then 1 to 5 days on site. The programme depends on the opening rather than the postcode, so it is set after the measured survey.
Does the distance to Angus and Dundee change the quote?
Any travel or access cost sits on its own line in the itemised quotation, so you can see it. Scaffolding, restricted delivery times and lifting gear tend to matter more than mileage.
Do roller shutters need planning permission in the Angus and Dundee area?
Usually yes, if they materially affect the external appearance. Class 9A doesn't name shutters, so in Scotland treat them as falling to the appearance test rather than assuming a permitted development route. Ask the council before ordering, as this is a reading of the rules and not an official statement.
Which way must a fire exit door open on a shop in the Angus and Dundee area?
In the direction of escape. Regulation 13(2) of the Fire Safety (Scotland) Regulations 2006 also rules out sliding and revolving doors on a dedicated fire exit and says fire exit doors can't be locked against immediate use. Duties sit with dutyholders under Part 3 of the Fire (Scotland) Act 2005, meaning the employer and any person with control of the premises.