For aluminium shopfronts across the Isle of Wight, we draw first and order later. You see a scale drawing with signed-off dimensions before anything is made, so the frontage on paper is the frontage you get.
Daylight is only half the brief for aluminium shopfronts, because a frontage keeps working after dark. Think about how the glass, the sign and the view inside will read to someone walking past at six o'clock on a winter evening.

How do we handle aluminium shopfronts for premises on the Isle of Wight?
Across the Isle of Wight, the same aluminium section can look sharp or wrong depending on what stands around it. We choose colour on site against the real brick, stone or render at your address, because a RAL chip under office lights tells you very little.
Few shop openings on the Isle of Wight or anywhere else are truly square, and aluminium shows it, because straight lines make any lean in a building obvious. We measure at several heights and widths, then decide where the difference gets hidden, which is usually behind the fascia and the pier covers.
What consents apply to aluminium shopfronts on the Isle of Wight?
England has no permitted development route for changing a shopfront. Part 7 Class A of the General Permitted Development Order 2015 excludes creating, altering or replacing one, and it allows no alterations at all on article 2(3) land. That leaves two outcomes for aluminium shopfronts at premises in the Isle of Wight area: a planning application, or work that doesn't materially affect the external appearance.
How much do aluminium shopfronts cost on the Isle of Wight?
The guide for aluminium shopfronts is £2,495 to £11,995 plus VAT for a typical 3 to 7 m frontage. Expect the lower end for simple work with clear access, and the upper end where detail, finish or awkward conditions add hours.
| Area | Isle of Wight |
|---|---|
| Nation | England |
| Towns covered | 4 |
| Main town | Newport |
| Planning regime | England: TCPA 1990 and the 2007 Advertisement Regulations |
| Building approval | Building Regulations (Approved Documents) |
| Survey | By arrangement |
Questions about aluminium shopfronts on the Isle of Wight
How long would an aluminium shopfront take on the Isle of Wight?
Typically 2 to 4 weeks to fabricate once drawings are signed off, then 1 to 5 days on site. The programme depends on the opening rather than the postcode, so it is set after the measured survey.
Do you fit aluminium shopfronts across the Isle of Wight?
Yes. We travel from Great Barr to survey and fit across the Isle of Wight, using vetted teams working under S&K Glazing with one named contact for the job.
Can you work with our shopfitter on the Isle of Wight?
Yes. We can supply the front as one package within a wider fit-out, working to the shopfitter's programme and agreeing the floor, ceiling and signage interfaces on the drawings.
What rules apply to a fire exit door through a shopfront in the Isle of Wight area?
It must open in the direction of escape and can't be locked against immediate use, and a dedicated fire exit can't be a sliding or revolving door. In England that comes from article 14(2) of the Regulatory Reform (Fire Safety) Order 2005, and the duty sits with the responsible person, normally the employer or whoever controls the premises for a business, otherwise the owner. An outward door can clash with section 153 of the Highways Act 1980 where it opens onto the footway, so raise it early.
Does a new shopfront in the Isle of Wight area need Building Regulations approval?
Assume yes until building control says otherwise. England has no like-for-like exemption, though registered installers can self-certify replacement windows and doors in non-dwellings. That route doesn't cover structural glass, curtain walling or revolving doors.