0800 088 6248 Get a guide price
  1. Home
  2. Services
  3. Fascia signage
  4. Comber

Fascia signage in Comber

Survey, drawings and a written price for fascia signage in Comber.

Good fascia signs are mostly a matter of spacing. For Comber premises we set letter height, margins and alignment from the door and window lines below.

A survey in Comber usually starts outside, looking at the whole elevation before any tape comes out, because the frontage has to answer the building above it.

Deep green shop fascia with built-up metal letters above a glazed entrance

How do you design around the building when planning fascia signage in Comber?

If the wall above your Comber shop is brick or stone, letters fixed straight to it may look better than a panel. We check the surface first, since soft brick needs a different fixing from hard stone.

Where the fascia on your Comber premises has been overclad, we lift a sample at survey to see what is underneath. Original timber, cornice mouldings or tile may be worth keeping, and they change what the new sign should be.

Where the footway outside your Comber premises is narrow, a recessed entrance earns its keep. It gives people a dry place to pause out of the walkway, and it adds a longer run of display glass either side of the door.

What might fascia signage cost in Comber?

As a working budget, use £395 to £1,995 plus VAT per sign. Your place inside that range for fascia signage depends mostly on how much of the existing frontage can stay and how much has to be put right first.

What permissions should you check for fascia signage in Comber?

Northern Ireland appears to have no permitted development route for a shopfront, as its 2015 Order mentions shops only in the Part 4 changes of use. For fascia signage at premises in the Comber area, expect a planning application unless the external appearance isn't materially affected. Ask the council to confirm the position.

A lit projecting sign in Northern Ireland can generally reach 1m² per surface and 1m high under Class 4(2). Projection is limited to 1m or two-thirds of the footway, so work to the smaller figure. At premises in the Comber area, anything bigger needs advertisement consent, and so does a lit sign in a conservation area.

For Comber, the usual route for planning and advert applications is through Ards and North Down Borough Council, and we confirm that when we visit.

Comber at a glance
TownComber
AreaCounty Down
Postcode districtsBT16, BT23
Planning authorityArds and North Down Borough Council
Building approvalBuilding Control (Technical Booklets)
SurveyFree for new work

Questions about fascia signage in Comber

Can a fascia sign in Comber be lit later on?

Yes, if the sign is planned for it. Built-up letters can take halo lighting when the panel and cable route are prepared at the start, which costs far less than adapting them afterwards.

What if the fascia behind my old sign in Comber is rotten?

We show you photographs and price the repair before going further. A short section of timber can often be spliced in, while a badly decayed fascia is better replaced with a new subframe.

Can a new fascia sign in Comber be fitted on a closed day?

Yes, we can arrange that, or fit out of hours if that suits you better. Most fascia signs take about a day, so the work can often go into your quietest trading hours.

What rules apply to a fire exit door through a shopfront in the Comber area?

It must open in the direction of escape, it can't be locked against immediate use, and a dedicated fire exit can't be sliding or revolving. In Northern Ireland that comes from regulation 13(2) of the Fire Safety Regulations (Northern Ireland) 2010, and duties sit with dutyholders, meaning the employer and any person with control of the premises, whom the Fire and Rescue Service calls the appropriate person. An outward door may also need Department consent under Article 56 of the Roads (Northern Ireland) Order 1993.

Does a shop sign in the Comber area need advertisement consent?

Not always. Under Northern Ireland's 2015 Regulations, an unlit sign within Class 5 generally needs no application, with a 5m top height and 0.3m letters, and neither does a lit sign within Class 4(2). That lit class isn't available in conservation areas, Areas of Outstanding Natural Beauty or National Parks, so ask first.

Planning fascia signage in Comber?

Send the address and a photo, and we'll come and measure it.

Call usGet a guide price