0800 088 6248 Get a guide price
  1. Home
  2. Guides
  3. Can a shopfront be fitted while we keep trading?

Can a shopfront be fitted while we keep trading?

Yes, in many cases, though rarely all at once. Most noisy work can be done on a closed day or out of hours, the door can often stay in use until the final stage, and the frontage is left secure at the end of every shift. Some frontages still need a short full closure, and the survey will show whether yours does.

Written by the Shopfront Specialists team. Checked November 2026.

Refurbished timber shopfront with fresh paint, new glass and a restored fascia on a brick parade

Can a shopfront be fitted while we keep trading?

Often, yes. The deciding factors are the width of the frontage, where the door sits, how many ways in you have and how large the panes are. A wide front with a door at one end can usually be phased bay by bay, whereas a narrow single-door unit leaves little room to work around customers.

We can arrange closed-day or out-of-hours installation, and the choice is usually a balance between disruption and cost. Night work carries higher labour rates, so a single day's closure can sometimes work out better than three nights of lost sleep and extra wages. Put real sales figures next to the quote and the answer becomes clearer.

ApproachSuitsWatch for
Closed dayRestaurants, salons, officesOne day may not cover strip-out and glazing
Overnight shiftsRetail on busy pitchesNoise, residents, delivery rules
Phased bay by bayWide frontages with two doorsLonger overall, more temporary screens
Short full closureNarrow units, major structural workLost trade, but the shortest programme

How do you keep the entrance open during the work?

Build the work around the door, and change the door last. New frames can usually go in on either side of a working entrance, and the final section is then swapped out in one closed session. Where the door is central, a temporary door set into a hoarding can carry customers during the changeover.

Escape comes first. Fire law stays in force throughout, so the route out must be kept clear and usable at every stage. In England and Wales the responsible person needs to know what is changing, and in Scotland and Northern Ireland the same goes for the dutyholders. Update the fire risk assessment for the period of the work if the exit changes.

Accessible routes need the same thought. A temporary threshold shouldn't leave a step for someone using a chair, and any covered walkway should keep a sensible width and clear headroom. Inclusive Mobility guidance gives 2100mm for scaffolding and suspended signs, and one Scottish council, Aberdeenshire, sets 2.4m under scaffolds.

What does overnight or closed-day working involve?

It involves doing the loud, dusty and risky parts when the shop is empty, and leaving the frontage secure and presentable by morning. Frames are assembled as far as possible beforehand, so that each section goes up and is glazed in one session and not left half finished.

Good preparation decides whether a night shift works. Steels and fixings can be set during earlier visits, and glass lifting should be planned with lighting, a clear pavement and a named person watching the public. Deliveries may have their own restrictions, and at a shopping centre the management will often set the hours, the route and the paperwork.

Neighbours matter too. Flats above the shop will hear drilling at midnight, so warn them and save the heaviest drilling for reasonable hours. Council noise officers usually respond better to a planned job that has told people in advance than to one that hasn't.

How is dust and noise kept away from stock?

An internal dust screen goes up before anything is touched, sealed at the floor, walls and ceiling. Stock near the window is moved or sheeted, and cutting happens outside wherever possible. Ventilation that pulls air from the frontage should be turned off, or the dust ends up everywhere.

Food businesses need extra care, because a dusty kitchen or counter can't simply be wiped down before service. Plan any cleaning into the programme, and hold the noisy work until after the last service. Salons and clinics face a different problem: a drill through a party wall can ruin an appointment even if the door stays open.

Smoke and heat detectors near the work are easily set off by dust. Discuss this before the first shift with the person responsible for the alarm, so that it is managed properly and without leaving the shop unprotected.

How is the shop kept secure during the work?

Every shift ends with the frontage closed: glazed, or boarded with a lockable door. An open or half-fixed bay should never be left overnight, so the work is sized to what can be finished and closed up in the time available.

Tell your insurer before work starts, as a temporary boarded frontage may change your cover. Alarm contacts and sensors will be disturbed, and an engineer should test them at the end of each stage. Keep a list of who holds keys while temporary locks are on, and collect those keys back at handover.

Do we need licences for scaffolding or hoardings?

Usually, if the scaffold or hoarding stands on the public highway. England and Wales have separate provisions for each, and s.172 of the Highways Act 1980 expects a close-boarded hoarding before external alterations unless it is waived. Scotland's s.58 doesn't name hoardings, so ask the roads authority.

Construction law applies too. On our reading a business client is a commercial client under CDM 2015 in Great Britain, so a project with more than one contractor needs a principal designer and principal contractor, and Northern Ireland has CDM (NI) 2016.

Licences take time to arrange, so ask for them as soon as the programme is drawn up, and make sure the hoarding design keeps the footway usable. A licence usually comes with conditions on hours, lighting and insurance, and those conditions belong in the method statement before the first scaffold tube arrives.

NationScaffoldHoarding
England and Waless.169 licences.172, close-boarded
Scotlands.58 written permissionNot named in s.58
Northern IrelandArt 72 consentArt 72

Common questions

Can you work on a Sunday?

Often, yes, as Sundays can suit businesses that close that day. Check any shopping centre rules and warn neighbours, because some leases and residents are less relaxed about it.

Does closed-day or overnight fitting cost more?

Usually, since unsocial hours and split shifts add labour. The quotation will show that line separately, so you can compare it with the cost of a closure.

What if a shopping centre limits our working hours?

Centre rules come first, so send us the fit-out handbook at survey stage if you have one. Permits, insurance documents and method statements usually have to be lodged before anyone can start.

Will my customers see a building site?

Only briefly, if the job is planned well. A clean printed hoarding with your opening date can work harder than a boarded window, and landlords often have rules about what it can show.

Related pages

Tell us about your frontage

Send the address and a photo. We'll come and measure it, at no cost.

Call usGet a guide price