0800 088 6248 Get a guide price
  1. Home
  2. Services
  3. Aluminium shopfronts
  4. County Down

Aluminium shopfronts in County Down

One contract and one named contact for aluminium shopfronts across County Down.

Our quotation for aluminium shopfronts in County Down is written, itemised and valid for 90 days. Nothing is ordered until you accept it, which gives you time to take it to a landlord, a partner or a board.

Openings are rarely square or level, so the survey for aluminium shopfronts records diagonals, pavement fall and head height at several points. Those few millimetres decide whether the finished front sits true against the building.

Dark bronze aluminium shopfront with slim frames, a low stallriser and a glazed entrance door

What makes aluminium shopfronts work well for premises in County Down?

Landlords with several units in County Down get the most from aluminium by fixing a house detail. One section, one colour and one stallriser height, agreed once, make every later unit simpler to draw and keep the parade consistent as tenants change.

Across County Down, the same aluminium section can look sharp or wrong depending on what stands around it. We choose colour on site against the real brick, stone or render at your address, because a RAL chip under office lights tells you very little.

What consents apply to aluminium shopfronts in County Down?

Northern Ireland appears to have no permitted development route for a shopfront, as its 2015 Order mentions shops only in the Part 4 changes of use. For aluminium shopfronts at premises in the County Down area, expect a planning application unless the external appearance isn't materially affected. Ask the council to confirm the position.

How much do aluminium shopfronts cost in County Down?

Guide price: £2,495 to £11,995 plus VAT for a typical 3 to 7 m frontage. Materials, finish and the amount of drawing and coordination involved all move it, and your itemised quotation shows where the money goes on aluminium shopfronts.

County Down at a glance
AreaCounty Down
NationNorthern Ireland
Towns covered8
Main townBangor
Planning regimeNorthern Ireland: Planning Act 2011 and the 2015 Advertisement Regulations
Building approvalBuilding Control (Technical Booklets)
SurveyFree for new work, from our Great Barr base

Does Newry, Mourne and Down District Council publish shopfront guidance?

Yes, Advice Guide 8 - General Principles of Good Shop Front Design. It tells applicants what the council expects from new and altered shopfronts. A few of the things it asks for:

  • Stall risers should be at least 500mm high, or reach the top of the pilaster base, with a moulded projecting sill below the glazing.
  • Ground-floor fascias should be about 600mm high, and acrylic or fluorescent materials are not acceptable.
  • Surface-mounted shutters will not receive planning permission, and unpainted galvanised shutters will not be permitted.

Read our summary of the Newry, Mourne and Down guidance

Questions about aluminium shopfronts in County Down

Do you fit aluminium shopfronts across County Down?

Yes. We travel from Great Barr to survey and fit across County Down, using vetted teams working under S&K Glazing with one named contact for the job.

Can premises in Bangor be fitted outside trading hours?

Usually, yes. Closed-day or out-of-hours installation can be arranged, and the noisy strip-out is planned first so the rest of the work disturbs neighbours less.

How long would an aluminium shopfront take in County Down?

Typically 2 to 4 weeks to fabricate once drawings are signed off, then 1 to 5 days on site. The programme depends on the opening rather than the postcode, so it is set after the measured survey.

What building approval does a shopfront in the County Down area need?

Usually a full plans application to Building Control in Northern Ireland, because building notices are for single dwellings. The Technical Booklets set the detail, with Booklet V for glass and Booklet R for access. Only dwelling windows and doors are exempt, so ask Building Control before assuming a like-for-like job falls outside the rules.

Do roller shutters need planning permission in the County Down area?

Usually yes, when they materially affect the external appearance. No permitted development route for shutters appears in Northern Ireland's 2015 Order, so treat them as falling to the appearance test. Check with the council before ordering.

Planning aluminium shopfronts in County Down?

Send the address and a photo, and we'll come and measure it.

Call usGet a guide price